Software and Calibrator Base Units

Default Signal Types and Base Units in ProCalV5 and DPCTrack2
 

Signal Types with Multiplier and Base Units

Signal Type

Multiplier

Base Unit

bar

1

BAR (Bars)

Deg C

1

DEGC (Degrees Celsius)

F

1

DEGF (Degrees Fahrenheit)

ftH2O

1

FTH2O (feet H2O @ 68Deg F)

g/cm2

1

G_PER_SQCM

Hz

1

HZ (Hertz)

inH2O

1

INH2O (in H2O @ 68Deg F)

inH2O 60F

1

INH2O_60DEGF (in H2O @ 60Deg F)

inHg

1

INHG (in Mercury @ 0 Deg C)

K

1

KELVIN (Degrees Kelvin)

kHz

0.001

HZ (Hertz)

kOhms

0.001

OHM

kPa

0.001

PA (Pascals)

mA

1

MA (milliamps)

mH2O

0.001

MMH2O (mm H2O @ 68 Deg F)

mHg

0.001

MMHG (mm Mercury @ 0 Deg C)

mmH2O

1

MMH2O (mm H2O @ 68 Deg F)

mmHg

1

MMHG (mm Mercury @ 0 Deg C)

mV

1000

V (volts)

Ohms

1

OHM

Pa

1

PA (Pascals)

psi

1

PSI (lbs/sq in)

R

1

DEGR (Degrees Rankine)

V

1

V (volts)

 

Fluke-supported Base Units
 

When selecting a base unit for a signal type, only some are compatible with Fluke calibrators.

 

Similarly for when a Custom Base Unit is selected for a Source or Measure mode setting using custom units.

 

OHM

DEGC

DEGF

DEGR

KELVIN

PSI

MMHG

INHG

INH2O @4DEGC

MMH2O @4DEGC

BAR

PA

kPA

G per Sq CM

inH2O @60F

mA

inH2O (interpreted at 20C)

ftH2O(interpreted at 20C) 

mmH2O (interpreted at 20C) 

mV

V

Hz

 

Was this article helpful?
0 out of 0 found this helpful

Articles in this section

2024 Client Training Schedule
See the full list of web training events scheduled for 2024. Watch completed training sessions or register for upcoming events.