Fluke Calibrator Debug Mode

Field Calibrator Debug Mode
 
Instructions to enable the debug logging: 
 
1.       Right click on application shortcut to bring up Properties.
 
The “Target” field will be something like

"C:\Program Files (x86)\Prime Technologies\ProCal V5\ProCalV5.exe"
 
Including the quote characters.
 
2.       Change the whole target field to:
"C:\Program Files (x86)\Fluke\ProCal V5\ProCalV5.exe" "-debug"
 
Please note the space between the “ after .exe and the “ before "-debug".
 
3.       Save the shortcut.
 
4.       Retry the operation again using this calibrator.
 
5.       After you try it you should see a log file in one of two places:
C:\Program Files (x86)\Prime Technologies\ProCal V5\ProCalV5.exeLOG.txt
 
Or
 
C:\Users\<your username>\AppData\Local\VirtualStore\Prime Technologies\ProCal V5\ProCalV5.exeLOG.txt
 
When this is run this way and an upload is run this same folder will contain a number of log files e.g. 020200415_122027_DEBUG.txt, which are basically a sequence number followed by the date and tie and then _DEBUG for debugging purposes.
 

 

 

 
 
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

2024 Client Training Schedule
See the full list of web training events scheduled for 2023. Watch completed training sessions or register for upcoming events.